A sludge pump kit easily converts a pressure washer into a light duty water pump!
Simple to use, just connect your gun/wand to the quick connect fitting, and get the hose in place for suction and discharge, and pull the trigger. (You will need a gun/wand setup that has the quick connect end on it, where you usually put the spray tips in)
• This suction power can pick up slurry, along with rocks and debris up to 3/4" in diameter
• Pump 10 times the flow rate of a pressure washer
• If you are using a pressure washer pumping 4 gpm, the output produced is about 40 gpm
• Lift up to 20 feet
• The kit comes with a sludge pump, 25’ discharge hose, 18” suction hose & hose clamps
• Inlet: 1/4” male QC
• Weight 12.0 lbs.