Accutek® S1099-DC Steel 90° Elbow 1/2 MPT x 3/8 MPT Hydraulic Fitting. Fairview's SAE steel pipe fittings create a stress-generated seal.
TECHNICAL DATA SHEET
INSTALLATION DATA SHEET
Specifications:• Applications - Water, Oil, Air • Working Pressure: 3,000 PSI• Burst Pressure: 12,000 PSI• Working Temperature: -65°F (-54°C) to 250°F (120°C) • Pipe threads must be sealed using approved thread sealant• Weight: 0.26 lbs
This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov/food.
Features:• Suitable for cold and hot water commercial pressure cleaning applications• Reinforcement: One layer of high tensile braided steel – R1 Rating• Cover: Wrapped finish with embossed lay line in grey “mark-less” cover color• Burst (Minimum): 3:1 working pressure • Impulse Life: 200,000+
Specifications: • Hose Inner Diameter: 3/8" ID• Length: 10’• Working (Maximum): Up to 4,000 PSI• Burst (Minimum): 12,000 PSI• Color: Grey, “mark-less”• Maximum Temperature: 250° F.• Ends: 3/8" MPT (1 solid & 1 swivel)• Weight 2.65 lbs
General Pump 3/8" 5,000 PSI Stainless Steel Quick Disconnect Fittings (1 Plug & 1 Socket)
Features: • Quick disconnect design• Body Material: 304 Stainless steel• 1 pc: General Pump 3/8 NPT-F Quick disconnect coupler socket with EPDM O-ring• 1 pc: General Pump 3/8 NPT-F Quick disconnect coupler plug• Max Temp: 175°• Max Operating Pressure: 5,000 PSI • Works with standard quick connects• Weight: 0.30 lb
Accutek® S1022-DC Steel Male Hex Nipple 1/2 Male Pipe x 3/8 Male Pipe Hydraulic Fitting. Fairview's SAE steel pipe fittings create a stress-generated seal.
Specifications:• Applications - Water, Oil, Air • Working Pressure: 3,000 PSI• Burst Pressure: 12,000 PSI• Working Temperature: -65°F (-54°C) to 250°F (120°C) • Pipe threads must be sealed using approved thread sealant• Weight: 0.13 lbs
PA RB 65 Red Adjustable Spray Was Down Gun with Swivel for Food Industry. RB65 suitable for use up to 350 PSI and 16 GPM. Shockproof gun with adjustable conical/pencil jet and Stainless Steel Shaft
Features• Low pressure gun with conical/pencil jet controlled by the trigger• Adjustable screw to vary cone width from 0° to 60°• Covered by semi-housings of non-stainable shockproof plastic, entirely sealed and with 3 rubber protective rings.• Plastic trigger protected by hand guard• Minimum fatigue for trigger opening and use• Internal structure in brass and Sst• Ergonomic construction• Inlet swivel connection
Specifications • Rated Pressure: 350 PSI• Rated Flow Rate: 16.0 GPM• Rated Temp: 195° F. • Casing Color: Red• Material: Brass• Piston Material: Sst. Ai303• Shaft Material: Stainless Steel• Swivel Inlet: 1/2" Bsp F• Weight: 37.39 oz
Copyright © 2023 PWMall.com. All Rights Reserved.