Fimco Replacement Pumps

Fimco Weed Wrangler 5281118, 5281560 1.0 GPM 60 PSI 12 Volt Diaphragm Pump. Replacement pump for spot sprayers, liquid fertilizer units, recreational activities, wash down or liquid transfer

Features:
• 1.0 GPM 12 Volt Automatic Demand
• In In-Line fuse protection – 5 Amp fuse
• Self priming
• Runs dry without damage
• Pumps are 100% flow and current tested at the factory

Specifications:
• Automatic demand diaphragm pump
• 12 Volt DC power
• 1.0 GPM max. flow
• 60 PSI pressure switch
• In-Line 5 AMP fuse protection
• 3/8” Hose barb connections
• Fimco Box #: 5151118
• Fimco Pump #: 5281560
• 1 Year consumer limited warranty
• Do not use for bleach or petroleum products
• Packaging: Small Box
• Weight: 1.50 lbs

Fimco HFP-124060-111 (5281370, 5151086) HIGH-FLO High Performance 1.2 GPM 60 PSI 12 Volt Diaphragm Pump. Replacement pump for spot sprayers, liquid fertilizer units, recreational activities, wash down or liquid transfer. High-Flo has designed a new level of demand pump. Engineered to strict tolerances and elevated standards which deliver the peak of efficiency, the new High Performance line of pumps from Fimco High-Flo represent the latest in pump technology Replaces & Upgrades Fimco Pump #5275086

Features:
• Increased Flow Rates
• Increased Motor Life
• Optimized Chamber Flow
• Improved Check Valves
• Chemical resistant elastomers
• Fan Cooled Motor
• Self priming – Up to 8‘
• Runs dry without damage
• 100% Factory tested
• Roundup® ready

Specifications:
• Automatic demand diaphragm pump
• 12 Volt DC power
• 1.2 GPM max. flow
• 60 PSI pressure switch
• Viton Valves
• Santoprene Diaphragm
• In-Line 5 AMP fuse protection – 4 AMP max draw
• 3/8” Hose barb connections
• Fimco Box #: 5151086
• Fimco Model #: HFP-12060-111
• Fimco Pump #: 5281370
• Replaces Fimco #'s 5277980, 5275086, 5275702, 5275496, 5273882, 5275015
• 2 Year consumer limited warranty
• 90 Day commercial limited warranty
• Do not use for bleach or petroleum products
• Weight: 1.55 lbs

Fimco 5281370/5151086 Pump Breakdown

Fimco 2.1 GPM 60 PSI Gold Series 5277995/5275814 High-Flo Duplex 12 Volt Diaphragm Pump with Internal Bypass and 3/8" FPT (Threaded) Ports. Replacement pump for spot sprayers, liquid fertilizer units, planters or back up water systems. Can also be used for potable water. Ready for Roundup®

Features:
• RELIEF VALVE MODELS have pressure controlled by an internal relief valve, and run continuously unless electric current is turned off
• Diaphragm design eliminates troublesome shaft seal
• Pump can be run indefinitely without damage
• Ball bearing drive - assures longer pump life
• Excellent self-priming capability
• Santoprene diaphragms and viton valves are standard
• Maximum temperature of pumped liquid 130°F
• Permanent magnet motor - long life brushes
• Fuse protected
• Built-in cooling fan

Specifications:
• Voltage: 12 VDC 8 AMPS Max
• Max Flow: 2.1 GPM
• Max Pressure: 60 PSI
• Ports(2): 3/8” Female NPT
• Two Pin Connector: 6” Long
• Fimco Box #: 5275814
• Fimco Pump #: 5277995
• DO NOT USE With Flammable Or Combustible Liquids
• Packaging: Small box
• Weighs 3.15 lbs

Fimco 5277995/5275814 Pump Breakdown

Fimco HFP-24060-113 (5281371, 5151087) HIGH-FLO High Performance 2.4 GPM 60 PSI 12 Volt Diaphragm Pump. Replacement pump for spot sprayers, liquid fertilizer units, recreational activities, wash down or liquid transfer. High-Flo has designed a new level of demand pump. Engineered to strict tolerances and elevated standards which deliver the peak of efficiency, the new High Performance line of pumps from Fimco High-Flo represent the latest in pump technology. Replaces & Upgrades Fimco Pump #5275087

Features:
• Increased Flow Rates
• Increased Motor Life
• Optimized Chamber Flow
• Improved Check Valves
• Chemical resistant elastomers
• Fan Cooled Motor
• Self priming – Up to 14 ‘
• Runs dry without damage
• 100% Factory tested
• Roundup® ready

Specifications:
• Automatic demand diaphragm pump
• 12 Volt DC power
• 2.4 GPM max. flow
• 60 PSI pressure switch
• Viton Valves
• Santoprene Diaphragm
• In-Line 10 AMP fuse protection – 8 AMP max draw
• Quick attach port connection with 1/2” MNPT, 3/8” Hose Barb & 1/2” Hose Barb fittings
• Fimco Box #: 5151087
• Fimco Model #: HFP-24060-113
• Fimco Pump #: 5281371
• Replaces Fimco #'s 5277981, 5275087, 5275703, 5275497, 5274517, 5275016
• 2 Year consumer limited warranty
• 90 Day commercial limited warranty
• Do not use for bleach or petroleum products
• Weight: 3.45 lbs

Fimco 5281371/5151087 Pump Breakdown

Fimco High-Flo Gold Series pumps are designed to pump water and aqueous solutions of common pesticides. They are not designed to pump petroleum products or other flammable materials. They are not designed to pump bleach solutions. Use of this pump for petroleum products or bleach solutions will void the warranty. When pumping liquids other than water, the pump should be flushed out with clean water after each use to prolong pump life

High-Flo Gold Series pumps are equipped with a demand switch that reacts to outlet pressure and shuts the pump motor off at a factory set pressure limit of 45 PSI. When the pressure drops below this preset limit the switch allows the pump motor to start again.

High-Flo Gold Series pumps are self-priming. Vertical prime will depend on the viscosity of the liquid and suction line size. Minimum recommended suction line size is 3/8 inch. All hose connections need to be tight or air leakage will break the prime and disrupt water flow. The installation of a 50 mesh strainer is recommended to prevent debris or other foreign material from entering the pump and causing pump failure. The pump should be mounted in a dry and adequately ventilated area. The pump can be mounted horizontally or vertically. If mounted vertically, the pump head should be down and the motor should be up. Your pump will come with adapters which will allow you to hook up to various plumbing configurations

Pump is rated at 3.8 GPM @ open flow. If the discharge plumbing is very restrictive or nozzle tips are undersized, the back pressure will cause the pump to cycle rapidly. This rapid cycling will increase the operating temperature of the motor and the amperage draw on the power supply. Extended use with this cycling will cause premature failure of the pump.

Pump is designed to run off of the battery of your ATV, lawn tractor, or other vehicle with a 12V system. If using a stand alone battery, use a deep cycle RV or marine battery.

The pump should be winterized before storage, by pumping a solution of RV antifreeze through it, and the entire plumbing system.

Fimco HFP-45060-113 5281372 HIGH-FLO High Performance 4.5 GPM 60 PSI 12 Volt Diaphragm Pump. Replacement pump for spot sprayers, liquid fertilizer units, recreational activities, wash down or liquid transfer. High-Flo has designed a new level of demand pump. Engineered to strict tolerances and elevated standards which deliver the peak of efficiency, the new High Performance line of pumps from Fimco High-Flo represent the latest in pump technology.

Features:
• Increased Flow Rates
• Increased Motor Life
• Optimized Chamber Flow
• Improved Check Valves
• Chemical resistant elastomers
• Fan Cooled Motor
• Self priming – Up to 14‘
• Runs dry without damage
• 100% Factory tested
• Roundup® ready

Specifications:
• Automatic demand diaphragm pump
• 12 Volt DC power
• 4.5 GPM max. flow
• 60 PSI pressure switch
• Viton Valves
• Santoprene Diaphragm
• In-Line 15 AMP fuse protection – 14 AMP max draw
• Fimco Model #: HFP-45060-113
• Fimco Pump #: 5281372
• 2 Year consumer limited warranty
• 90 Day commercial limited warranty
• Do not use for bleach or petroleum products
• Weight: 4.95 lbs

Fimco 5281372 Pump Breakdown

Fimco HFP-45060-113 (5281372, 5151088) HIGH-FLO High Performance 4.5 GPM 60 PSI 12 Volt Diaphragm Pump. Replacement pump for spot sprayers, liquid fertilizer units, recreational activities, wash down or liquid transfer. High-Flo has designed a new level of demand pump. Engineered to strict tolerances and elevated standards which deliver the peak of efficiency, the new High Performance line of pumps from Fimco High-Flo represent the latest in pump technology. Replaces & Upgrades Fimco Pump #5275088

Features:
• Increased Flow Rates
• Increased Motor Life
• Optimized Chamber Flow
• Improved Check Valves
• Chemical resistant elastomers
• Fan Cooled Motor
• Self priming – Up to 14‘
• Runs dry without damage
• 100% Factory tested
• Roundup® ready

Specifications:
• Automatic demand diaphragm pump
• 12 Volt DC power
• 4.5 GPM max. flow
• 60 PSI pressure switch
• Viton Valves
• Santoprene Diaphragm
• In-Line 15 AMP fuse protection – 14 AMP max draw
• Quick attach port connection with 1/2” MNPT & 1/2” Hose Barb fittings
• Fimco Box #: 5151088
• Fimco Model #: HFP-45060-113
• Fimco Pump #: 5281372
• Replaces Fimco #'s 5277982, 5275088 , 5275704, 5275498, 5275017
• 2 Year consumer limited warranty
• 90 Day commercial limited warranty
• Do not use for bleach or petroleum products
• Weight: 5.50 lbs

Fimco 5281372/5151088 Pump Breakdown

Fimco High-Flo Pro Series 2.2 GPM 100 PSI 12 Volt Diaphragm Pump. Professional grade pump with upgraded elastomers is ideal for use with harsh chemicals and oil-based chemicals with surfactants

Features:
• High-Flo 12 Volt Pro Series Pump; 2.2 GPM
• Professional Grade Pump - Upgraded Elastomers
• Geolast® Diaphragm
• Heavy Duty Motor

Specifications:
• Voltage: 12 VDC 12 AMPS Max
• Max Flow: 2.2 GPM
• Switch Off Pressure: 100 PSI
• Recommended Slow Blow Fuse: 15 AMP
• Diaphragm: Geolast®
• Check Valve: Viton
• 1/2”-14 NPT Male Threads
• Two Pin Connector: 6” Long
• Includes Retrofit Kit
• Fimco Box #: 5281325
• Fimco Model #: HFP-2.2
• Fimco Pump #: 5151075
• DO NOT USE With Flammable Or Combustible Liquids
• Packaging: Small box
• Weighs 5.3 lbs

Fimco High-Flo Pro Series 4.0 GPM 45 PSI 12 Volt Diaphragm Pump. Professional grade pump with upgraded elastomers is ideal for use with harsh chemicals and oil-based chemicals with surfactants

Features:
• High-Flo 12 Volt Pro Series Pump; 4.0 GPM
• Professional Grade Pump - Upgraded Elastomers
• Geolast® Diaphragm
• Heavy Duty Motor

Specifications:
• Voltage: 12 VDC 12 AMPS Max
• Max Flow: 4.0 GPM
• Switch Off Pressure: 45 PSI
• Recommended Slow Blow Fuse: 15 AMP
• Diaphragm: Geolast®
• Check Valve: Viton
• 1/2”-14 NPT Male Threads
• Two Pin Connector: 6” Long
• Includes Retrofit Kit
• Fimco Box #: 5281326
• Fimco Model #: HFP-4.0
• Fimco Pump #: 5151073
• DO NOT USE With Flammable Or Combustible Liquids
• Packaging: Small box
• Weighs 6.45 lbs

• Fimco Optional Accessorie for 3 Point Sprayers
• Hypro 6 roller pump with 1320-0022 coupler
• 540 RPM